PDA

View Full Version : Drawbridge unwanted rotations



lil_joha
02-16-2017, 03:18 PM
is it normal for a drawbridge in a prefab to rotate out of alignment when importing?

Guppycur
02-16-2017, 04:50 PM
Hadn't seen that; what method are you using to import? It may be that.

lil_joha
02-17-2017, 04:54 AM
Using Hals Prefab editor. Exported to editor , worked on some stuff, then imported back in. I did not touch the drawbriges. After a few rounds of importing as I edited items I found in need of rotations again without touching the drawbridge. I went out and found them at right angles to where they were supose to be. and I was unable to hit them to destroy them to place new ones but when I edited them out they did leave.

I just went from there without the draw bridges until I figure out what went wrong still editing the structure just leaving the front door wide open.

Guppycur
02-17-2017, 09:55 AM
Definitely get with Hal on that.